Hi,
In my Cortex-M0 project, there are two program images residing at different memory locations: 0x0000_0000 and 0x0010_0000. Each program has its own vector table. M0 will boot from the program at 0x0010_0000 then switch to the other program (0x0000_0000) at the end.
What is the correct way to switch to the porgram at 0x0000_0000? I'm not sure whether the following instructions are correct or not.
LDR R6, =0x1 ; set R6 to 0x0000_0001 due to Thumb mode
LDR R0, [R6]
MOV SP, R0
LDR R1, [R6, #4]
BX R1
Can someone please point me the right implementation? Thanks a lot.
Hi wshen,
I would like to ask you how you can have two set of vector tables.
Best regards,Yasuhiko Koumoto.
Hi Yasuhiko,
It appears I have misunderstanding of vector tables on M0. There could be only one vector table existing on M0.
Thanks,wshen
If you can replace the Cortex-M0 by a Cortex-M0+, you would have the VTOR, so you could change vector tables.
Sometimes the vendor of the device makes a pin-compatible device that can replace it.