Architectures and Processors forum AXI Write Access: WLAST/WVALID handling

State Accepted Answer
+1 person also asked this people also asked this
Locked Locked
Replies 1 reply
Subscribers 350 subscribers
Views 5162 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AXI Write Access: WLAST/WVALID handling

sxuser over 11 years ago

Can I set WLAST high while WVALID is low? The AXI specification is not clear at this point.

Top replies

Xingguang Feng over 11 years ago +1 verified

Hello, > Can I set WLAST high while WVALID is low? Yes, you can. The payload is "don't care" while the corresponding VALID signal is low. Xingguang

Parents

+1 Xingguang Feng over 11 years ago

Hello,
> Can I set WLAST high while WVALID is low?
Yes, you can. The payload is "don't care" while the corresponding VALID signal is low.
Xingguang
Cancel
Vote up +1 Vote down

Cancel

Reply

+1 Xingguang Feng over 11 years ago

Hello,
> Can I set WLAST high while WVALID is low?
Yes, you can. The payload is "don't care" while the corresponding VALID signal is low.
Xingguang
Cancel
Vote up +1 Vote down

Cancel

Children

No data