This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Design Start ARM Cortex-M0

Hi,

I trying to build the peripheral around Cortex-M0 IP core thorugh AHB-lite system. Right now I have to integrate Cortex-M0 with the DDR2 SRAM (1Gb) through AHB lite.

I searched on  internet which shows interfacing only through core generator (MIG). Is there a way I can use  Xilinx core generator to interface through AHB lite system.

I am using  Atlys Xilinx Spartan 6.


I also have some  example SoC design which interface 128Mb SRAM  to Cortex-M0 though AHB lite for Nexsys 3 board . But the Board I am using  has DDR2 RAM.


Thanks

Parents
  •     Hi,

          i)  I was wondering how much on chip memory I can get  on spatran 6 FPGA  with cortex M0 running in it.

         ii)  Making DDR2 controller  would be big task.

         iii)   I  was trying for the CMSDK( cortex M system design Kit). Is there module available like AHB to SRAM and  for  other peripheral?  Is there any licencing fee for getting it? 

          iv)  I have zynq 7000 board available in my lab. I checked It has it own cortexA9 processor and XADC as well.   But changing board would  take time.

Reply
  •     Hi,

          i)  I was wondering how much on chip memory I can get  on spatran 6 FPGA  with cortex M0 running in it.

         ii)  Making DDR2 controller  would be big task.

         iii)   I  was trying for the CMSDK( cortex M system design Kit). Is there module available like AHB to SRAM and  for  other peripheral?  Is there any licencing fee for getting it? 

          iv)  I have zynq 7000 board available in my lab. I checked It has it own cortexA9 processor and XADC as well.   But changing board would  take time.

Children