This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

debug mode with Keil μVision 5

Tekel over 7 years ago

Hello
I am new to the community and new to the ARM processor. I'm not even at the front door of this world and I already have a problem because when activating the debug mode, I get this message "Error Could not load file" and this "Debugger aborted!"
thank you for helping me

Top replies

Joseph Yiu over 7 years ago +1 verified

If you are using Keil Microcontroller development kit, there are a range of application notes to show you how to get started http://www.keil.com/appnotes/list/arm.htm Also see Get started guide in...

+1 Joseph Yiu over 7 years ago

If you are using Keil Microcontroller development kit, there are a range of application notes to show you how to get started

http://www.keil.com/appnotes/list/arm.htm

Also see Get started guide in http://www.keil.com/arm/uv-gettingstarted.asp
Cancel
Vote up +1 Vote down

Cancel