Hello, i am having trouble in flashing a simple program in to a 8051 device with a usb kit. The device i am using is a "at89c51ic2"
when i build target does not show any error or warning, but when i try to flash, this error shows up:
with this i went to the "options for target" ->"utilities" to make sure but i did not found nothing :(
this is what is the box:
"-autoisp -device $D -hardware RS232 -port COM5 -baudrate 9600 -operation MEMORY FLASH LOADBUFFER "#H" PROGRAM START RESET 00"
if anyone could help finding the problem it would be great, i am losing my mind :'(
sorry for my bad english
thank you for the response, the "batchisp" was the problem as you suggested. What happened that this 8051 usb kit was the first i used as a student before i reset my PC and lost all the necessary programs for programming this 8051 kit. yesterday i found it and wanted to try to do something with it, but i did not remembered of the total configuration of the "Keil uVision", but worst i forgot to install a program called "FILP" that it is intended to help in the communication with the 8051 kit, and when you pointed it i installed it and put the right path to it.
thank you very much :))