Hello, i am having trouble in flashing a simple program in to a 8051 device with a usb kit. The device i am using is a "at89c51ic2"
when i build target does not show any error or warning, but when i try to flash, this error shows up:
with this i went to the "options for target" ->"utilities" to make sure but i did not found nothing :(
this is what is the box:
"-autoisp -device $D -hardware RS232 -port COM5 -baudrate 9600 -operation MEMORY FLASH LOADBUFFER "#H" PROGRAM START RESET 00"
if anyone could help finding the problem it would be great, i am losing my mind :'(
sorry for my bad english
As Westonsupermare Pier suggests, the PATH environment would have to be set correctly to run the 'batchisp' command as shown.
This applies whether you run it manually from the command prompt, or get uVision to do it - hence the suggestions to try it from a command prompt.
Alternatively, supply the complete path to the executable - as shown here:
http://www.keil.com/support/docs/2880.htm
thank you for the response, that was indeed the problem.
after i install "FLIP" was just put the right path and it worked!!!
it can flash the memory of the MCU with the program.