• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 122 subscribers
  • Views 19484 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pin output last state when programming

Yariv

Hi all,

I'm using IAR 6.5 with MSP430, sometimes when I program the MCU the output pin goes on 'H' instead of 'L' and causing power failure (due to the analog function of that pin).

My assumption when I close the debugger while this pin in 'H' state it wont go down.

Is it possible to make sure the pin state while programming will stay on 'L'

Thanks,

Yariv