• State Accepted Answer
  • Locked Locked
  • Replies 1 reply
  • Subscribers 15 subscribers
  • Views 6147 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error: Cannot Load Flash Programming Algorithm!

simosilva

Hi, i have these problem and searched fore different solutions but none worked for me, i will explain here.

Environment:

  • Keil 5.34
  • STM32H745I-DISCO (with embedded ST-LINK/V3)
  • Code generated with STM32CubeMX
  • Pack Keil.STM32H7xx_DFP.2.7.0

The Keil program searches into C:\Users\username\AppData\Local\Arm\Packs\Keil\STM32H7xx_DFP\2.7.0\Flash\STM32H7xx.FLM, but the current FLM is into C:\Users\silvestros\AppData\Local\Arm\Packs\Keil\STM32H7xx_DFP\2.7.0\CMSIS\Flash\STM32H7xx.FLM

Things that I've tryed:

  1. reinstall the Pack Keil.STM32H7xx_DFP.2.7.0 -> nothing appened
  2. Copying the Flash folder where the Keil searches for it -> nothing appened
  3. Reflashed and updated the ST-LINK firmware -> nothing appened
  4. As suggested here https://community.st.com/s/question/0D50X0000APZgDi/cannot-flashdebug-stm32f072-discovery-board tryed erasing the full chip with ST-lLINK Utility -> nothing appened

With some ST examples (with the relative keil project) I'm able to correctly flash the firmware, I cheched the debugger config and seems the same to my eyes.

Don't know what else to do.

Thanks

0