This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Boot busy box on the SATA instead of removable USB

I installed busybox on the USB drive, however, I cannot find an option to install it on the pre-installed SATA drive on the morello board. Please let me know the process.

Thanks

Top replies

Jx Tx over 2 years ago in reply to Patrik +2

Hi Patrik, thank you for your answer, My problem is Morello does not act like any other device. At least I have not used one before. You suggested, "If you want to update the SATA disk you must...
Deepak Pandey over 2 years ago +1

Hello Rabia, Please Refer https://git.morello-project.org/morello/docs/-/blob/morello/mainline/user-guide.rst section 5.4. "Using on-board SATA drive". best regards Deepak
Deepak Pandey over 2 years ago in reply to Jx Tx +1

Hello Rabia, The SATA would be discovered on the target board . Please use AP UART console , or you could probably connect to the booted board through ssh. best regards Deepak

Parents

0 Patrik over 1 year ago in reply to Jx Tx

Hi Rabia,

Sorry for the delay.

I am a bit unsure what you are trying to do.

If you want a boot for a USB MSD when booting you will see a (on both the HDMI and AP uart)

Press ESCAPE for boot options

If you press ESC then you cna select you USB MSD in Boot Manager.

The USB-B connector ("DBG USB") is only to debug and access the board internal UARTs. You can not send a boot image over the DBG USB.

Best regards,
Patrik
Cancel
Up 0 Down

Cancel

Reply

0 Patrik over 1 year ago in reply to Jx Tx

Hi Rabia,

Sorry for the delay.

I am a bit unsure what you are trying to do.

If you want a boot for a USB MSD when booting you will see a (on both the HDMI and AP uart)

Press ESCAPE for boot options

If you press ESC then you cna select you USB MSD in Boot Manager.

The USB-B connector ("DBG USB") is only to debug and access the board internal UARTs. You can not send a boot image over the DBG USB.

Best regards,
Patrik
Cancel
Up 0 Down

Cancel

Children

No data