This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

OpenCL support on Juno board

Nathan over 11 years ago

From the Juno ARM Development Platform - ARM link, i understand that Juno board has linux kernel support for Mali GPU.Does it have OpenCL support so that i can run OpenCL applications on Mali GPU?

Why one may need to have OpenCL compiled for ARM? What may be the possible scenario for this?

Thanks

Nathan

Top replies

Michael McGeagh over 11 years ago +1 verified

Hi nathan, The Juno does indeed contain a Mali T760 T628* MP4 GPU, which indeed is capable of running OpenCL 1.1 Full Profile. However, currently the BSP released by Linaro does not have it enabled...

Parents

0 Alban Rampon over 11 years ago

This question is a word for word duplicate of OpenCL support on Juno board which was posted a bit earlier.

I am closing this thread to avoid similar discussions in parallel.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Alban Rampon over 11 years ago

This question is a word for word duplicate of OpenCL support on Juno board which was posted a bit earlier.

I am closing this thread to avoid similar discussions in parallel.
Cancel
Vote up 0 Vote down

Cancel

Children

No data