This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How could I make sure the driver work success?

Note: This was originally posted on 3rd November 2011 at http://forums.arm.com

Dear all,

I'm trying to build linux Mali200 driver in arm system.
I build mali.ko and insert it success in linux.
The attachment is log when I insert module.
It always told me "Mali device driver r2p2-03rel0 loaded".

Would you please tell me how could I make sure the driver work success?
Because I try to run the SimpleProject.
It always get the error message "Error: No EGL Display available at src/egl_runtime.c:64"

thanks.

James

Parents

Pete over 12 years ago

Note: This was originally posted on 22nd November 2011 at http://forums.arm.com

Hi James,

I haven't forgotten about this question. I've been able to replicate some of your setup here, and hope to have some more information to share with you soon.

Cheers, Pete
Cancel
Vote up 0 Vote down

Cancel

Reply

Pete over 12 years ago

Note: This was originally posted on 22nd November 2011 at http://forums.arm.com

Hi James,

I haven't forgotten about this question. I've been able to replicate some of your setup here, and hope to have some more information to share with you soon.

Cheers, Pete
Cancel
Vote up 0 Vote down

Cancel

Children

No data