• State Accepted Answer
  • +2 person also asked this people also asked this
  • Locked Locked
  • Replies 14 replies
  • Answers 1 answer
  • Subscribers 138 subscribers
  • Views 43182 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cross-Compile ArmNN on x86_64 for arm64

fatimak

Hi ,

I am looking for someway of using the armNN SDK on a Xilinx Zynq Platform which has Quad-core ARM® CortexTM-A53 MPCoreTM up to 1.5GHz and an ARM MALI 400 MP2 GPU. With ARM Mali GPU noted off in a previous question my next task is to look into if it is possible to run the SDK on the Cortex processor but lloking at the guides I would only be able to cross compile it. So my first question is that is it possible to run it on the ARM A53 on the Zynq Platform and also if tensorflow would run on it as well.

Regards

Fatima

Parents
  • 0 in reply to Jason Andrews

    Hi, thanks for your great advice, but for now I have another problem.

    I'm a Xilinx FPGA user, now I have complete the build process for armnn which mean I have generated the .so file and UnitTest can execute successfully on my ZCU104.

    But the rest of my code is compiled and build on my IDE like this

    The makefile is generated by IDE, which i can use GUI to config make setting

    The setting I frequently use is this two

    Directories

    Libraries

    Which indicate the -i and -l command in makefile

     so what file should I extract so that I can build armnn software in this IDE?

Reply
  • 0 in reply to Jason Andrews

    Hi, thanks for your great advice, but for now I have another problem.

    I'm a Xilinx FPGA user, now I have complete the build process for armnn which mean I have generated the .so file and UnitTest can execute successfully on my ZCU104.

    But the rest of my code is compiled and build on my IDE like this

    The makefile is generated by IDE, which i can use GUI to config make setting

    The setting I frequently use is this two

    Directories

    Libraries

    Which indicate the -i and -l command in makefile

     so what file should I extract so that I can build armnn software in this IDE?

Children
No data