• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 1 reply
  • Subscribers 19 subscribers
  • Views 11019 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No Target Connected

Former Member
Former Member

Hi friends,
I was trying download my codes on tm32f030 and everything was ok but suddenly Keil start to give "No Target Connected" I tried some ways but no solution.Any idea?

I m using STM HAL library and CubeMX,uVİsion V5.23,ST Link Utulity V4

Thanks

Parents
  • Former Member
    +1 Former Member

    Finally I found the solution this is about SYS,for example PA13 and PA14 pins might be set free because these pins is related Debug Serial Wires.

Reply
  • Former Member
    +1 Former Member

    Finally I found the solution this is about SYS,for example PA13 and PA14 pins might be set free because these pins is related Debug Serial Wires.

Children
No data