Hello, when I try to use EventRecorder with STM32H753, it does not shows all the threads, it only shows below:
I actually following the steps following links µVision User's Guide,EventRecorder setup as below, the 400000000 is following the MCU clock speed
RTX5 config. h setting are as below
my Debug setting is as below using STlink V3 debugger
and in my STM32MX i do setup the debug as below
Please tell me what went wrong?
HiI see the same behavior. Is your system still running?
Because my system runs into a hard fault but the event recoder looks the same
I running a STM32U5A9.
Thanks and kind regards