• State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 22 subscribers
  • Views 1062 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Keil uVision 5.06u7- no "Device" in Run-time environment window.

ARMEDn

Hello,

I had Keil running quite well for a few months but that changed two days ago after I installed STM32 software, CubeIDE, CubeProgrammer and Monitor.

I now the following error:

Finished: 2 information, 1 warning and 1 error messages.
".\myFirst.axf" - 1 Error(s), 1 Warning(s).
Target not created.
Build Time Elapsed:  00:00:01

Whether old project or new project, I get the same error. I get the error in the image when I create new project I do not have the "Device" options listed at all in run-time environment window.

Parents
  • 0 Arm Employee Badge

    The device component comes from a CMSIS Device Family Pack (DFP). All CMSIS software packs are located in the folder you specified during the MDK installation. I don't know how the installation of ST Cube can change anything there. I would delete and re-install the DFP for the device used in your project in the Pack Installer and would try again.

     

Reply
  • 0 Arm Employee Badge

    The device component comes from a CMSIS Device Family Pack (DFP). All CMSIS software packs are located in the folder you specified during the MDK installation. I don't know how the installation of ST Cube can change anything there. I would delete and re-install the DFP for the device used in your project in the Pack Installer and would try again.

     

Children
No data