This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need a little guidance to use your OBD CAN code in STM32 CubeIDE

Hey Sir,

I'm Ashu Tamar student of BTech ece I want to make an OBD car project as my major project, I read about CAN protocol and its filtering but I'm not able to use filters in stm32 directly so I google & found your repo https://github.com/ARoozitalab/ELM327-OBDII-STM32 but when I'm trying to run your code in stm32cubeIDE and facing so many errors as I am new to programming so just guide me

If you help me will be thankful to you

Ashu Tamar

BTech Student ECE 2nd Year

Ganga Institute Of Technology And Management

Top replies

Milorad Cvjetkovic over 2 years ago +2 verified

You are in the wrong forum. You should ask questions relating to STMicroelectronics tools and code on STMicroelectronics' forum here: https://community.st.com/s/

+1 Milorad Cvjetkovic over 2 years ago

You are in the wrong forum.

You should ask questions relating to STMicroelectronics tools and code on STMicroelectronics' forum here: https://community.st.com/s/
Cancel
Vote up +2 Vote down

Cancel
0 Ashu Tamar over 2 years ago in reply to Milorad Cvjetkovic

Okay sir
Cancel
Vote up 0 Vote down

Cancel