This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The selection cannot be launched and there are no recent launches stm32cubeide

Hello all,

As a C++ Programmer who aims at starting learning embedded programming on Arm based MCUs using C++, I went for this tutorial to program my STM32F411RE Nucleo-64 board for the first time. At stage 5 in that tut, when I need to debug the project, I get the following error message:


I tried to find the issue and work it out but no success yet! 
Do you have an idea what the problem might be and how to solve it, please?

Parents
  • Thank you for the link you provided me with.
    I actually found the issue just by messing with the files, say, the .project file! That file exists in a little further directory in the address shown in the tutorial. That is, we need to go further to ...\GPIO_InfiniteLedToggling\SW4STM32\STM32F411-Nucleo on the Import Source. That way the project debugs, and runs successfully on the board as expected.

    PS: That's really sad why ST company doesn't care about the contents offered in their tutorials especially when a starter is going to use them to begin learning embedded programming! :(

Reply
  • Thank you for the link you provided me with.
    I actually found the issue just by messing with the files, say, the .project file! That file exists in a little further directory in the address shown in the tutorial. That is, we need to go further to ...\GPIO_InfiniteLedToggling\SW4STM32\STM32F411-Nucleo on the Import Source. That way the project debugs, and runs successfully on the board as expected.

    PS: That's really sad why ST company doesn't care about the contents offered in their tutorials especially when a starter is going to use them to begin learning embedded programming! :(

Children
No data