Support forums

Keil forum Do I have to define some kind of path?

State Accepted Answer
+1 person also asked this people also asked this
Locked Locked
Replies 3 replies
Subscribers 20 subscribers
Views 1359 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Do I have to define some kind of path?

Bryant11 over 2 years ago

Hi all, I'm trying to make a project about Keil uVision setup for Stm32F103 and St-Link V2. When I build the project I get: RTE/Device/STM32F103C8/system_stm32f10x.c(65): error: 'stm32f10x.h' file not found

Thank you in advance.

Top replies

rkopsch over 2 years ago +1 verified

Just install the corresponding Device Family Pack Keil::STM32F1xx_DFP:

0 Grant B over 2 years ago

Did you run the Pack Installer for that device?
Cancel
Up 0 Down

Cancel
0 Annie over 2 years ago

Hi Bryant11, did Grant B help with this question? If so, please mark the reply as a suggested answer. Many thanks.
Cancel
Up 0 Down

Cancel
+1 rkopsch over 2 years ago

Just install the corresponding Device Family Pack Keil::STM32F1xx_DFP:
Cancel
Up +1 Down

Cancel