We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello,
I'm trying to run automate test for measuring current consumption with a ULINKPlus probe on an STM32L496ZG board.
With Keil IDE, you can open a project in debug mode and run commands with .ini file. The automate process runs very well, but the debug mode and the SWD adaptater adds stray current to the measure.
There is a way to avoid this stray current : the "Energy measurement without debug" mode of the ULINKPlus probe.
Is there a way to automate the same kind of measurment process with the mode "Energy measurement without debug" of th ULINKPlus probe ?
Thanks