Jlink EDU - Debug wrong start location

Good morning

I have a problem very strange with mi Jlink and i was hoping that you could help me

I will put you in context:

I am using a Jlink EDU for a proyect that i am doing at home, but when i debug the following happens to me

    - WHen i go into debug or do a reset from the IDE, it goes to a wrong memory location (link screenshot).
    if i put the pc the correct memory location, it debugs correctly but when i do a reset from the IDE, it backs to the wrong location (yes its always the same).
    if i program the MCU, and i get it to run withouth the IDE, flasher connected, all works fine.

    - I have tried various configurations and reviewed posts and I don't see the problem.
    - I have checked that the flash settings are correct.
    - I have tried to uninstall the IDE and the Jlink Driver.
    - I have tried in other computer.
    - I have tried others versions (MDK 5.32, JLink 6.88a).

I am using this versions:
 - uVision MDK 5.33
 - MCU: STM32G484
 - Jlink Software: 6.94b


What can I do?
what could be happening to me to make me start in this position?

Thank very much for you help
Kinds Regards