• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 24 subscribers
  • Views 1520 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Profile sampling from keil

amarr

Hi everyone,

Present i am working with QN9080 Evalboard(NXP) and  for code developing i am using keilv5. My aim is to create profile sampling for my project file.

I am using J-Link plus for programming/flashing hex file/bin file  into target file.

how can get it by using keil? what kind of config i do in keil?

Thank you inadvance,

Regards,

amarr

Parents
  • 0

    Look under Execution Profiler in the uVision help. Per the help, instruction-level profiling on hardware is only available with debuggers that support the ETM interface, such as the ULinkpro or a Segger J-Trace PRO. However, the QN9080 doesn't provide a connector to access the ETM signals.

    I suggest using the Event Recorder. You can get a lot of useful information from that. Or, use the simulator debug target for as much of your code as you can.

Reply
  • 0

    Look under Execution Profiler in the uVision help. Per the help, instruction-level profiling on hardware is only available with debuggers that support the ETM interface, such as the ULinkpro or a Segger J-Trace PRO. However, the QN9080 doesn't provide a connector to access the ETM signals.

    I suggest using the Event Recorder. You can get a lot of useful information from that. Or, use the simulator debug target for as much of your code as you can.

Children