This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with debugging mode

Hellcat over 4 years ago

I was using Keil 5 to debug my code on #1 board, somehow the code was kind of stuck, it has no response to reset, and cannot run anywhere, the same code works with no issue on the other self-build board(these two are basically the same), this #1 board works also with no issue earlier today, this situation just suddenly happened. It has no problem with compile, download, enter debug mode.... I`ve drained my brain and cannot figure out what is wrong,,, any suggestions??

Thanks in advance.

Top replies

rkopsch over 4 years ago +1 verified

I consider that we talk about MDK 5. My recommendation is to install our todays latest release MDK 5.33: http://www2.keil.com/mdk5 and to compare if the issue persists. In case it does, check if...