This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

not a genuine st device abort connection

i'm using bluepill stm32f103c8 board on keil ide . the debugger i'm using is ST LINK 2, but when i tries to programme the board it is showing NOT A GENUINE ST DEVICE ABORT CONNECTION

so how can i resolve this problem????

Top replies

rkopsch over 5 years ago +1

See i.e.: https://www.keil.com/support/docs/3662.htm But also: https://www.keil.com/support/docs/4139.htm https://www.keil.com/support/docs/4088.htm https://community.arm.com/developer/tools...

Parents

0 rkopsch over 5 years ago

See i.e.:

https://www.keil.com/support/docs/3662.htm

But also:

https://www.keil.com/support/docs/4139.htm

https://www.keil.com/support/docs/4088.htm

https://community.arm.com/developer/tools-software/tools/f/keil-forum/36524/error-not-a-genuine-st-device-abort-connection
Cancel
Vote up +1 Vote down

Cancel

Reply

0 rkopsch over 5 years ago

See i.e.:

https://www.keil.com/support/docs/3662.htm

But also:

https://www.keil.com/support/docs/4139.htm

https://www.keil.com/support/docs/4088.htm

https://community.arm.com/developer/tools-software/tools/f/keil-forum/36524/error-not-a-genuine-st-device-abort-connection
Cancel
Vote up +1 Vote down

Cancel

Children

No data