Keil forum Debug Problem with STM32L011

State Accepted Answer
Locked Locked
Replies 4 replies
Subscribers 21 subscribers
Views 3648 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Debug Problem with STM32L011

Reinhold over 4 years ago

I want to debug my source code with µVision V5.29

when I start the Simulator, the program starts at the correct program address (0x8001F5C) and the debugging is ok.

But when I start the hardware debugging with the STLINK-V2 the program starts at wrong address ( 0x1FF000FC).

I have no idea what happen there. Does anybody have any idea what's going wrong?

Best regards Reinhold

Top replies

Robert McNamara over 4 years ago +2 verified

You have booted into "System Memory" Look in the Reference Manual for the Boot Configuration section. It will show you how to configure the board to boot from Flash, System Memory or Embedded SRAM. The...

Parents

0 Reinhold over 4 years ago in reply to Robert McNamara

Thanks for the excellent tip!
After checking the boot configuration and the corresponding bits, the program starts at the right place as wanted.
Thanks a lot!
Cancel
Up 0 Down

Cancel

Reply

0 Reinhold over 4 years ago in reply to Robert McNamara

Thanks for the excellent tip!
After checking the boot configuration and the corresponding bits, the program starts at the right place as wanted.
Thanks a lot!
Cancel
Up 0 Down

Cancel

Children

0 Andy Neil over 4 years ago in reply to Reinhold
Cancel
Up 0 Down

Cancel