This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

can't find any device after installing the package

i have a board nucleo-L452RE-p 
i installed the package keil.STM32L4xx_DFP.2.3.0 on my keil MDK, 
i have also installed the STM32CubeL4 package from ST's website.
but when i try to start a new project, my processor family is not there in the board selector page. i've added the screen shots for the above problem too, please help me out.

Parents
  • i checked the windows explorer directory you mentioned and the pack was there. the issue was with the installation hence i uninstalled everything related to keil and did a fresh install with a fresh licence and it worked. my MCU is visible now. thanks for the help.

Reply
  • i checked the windows explorer directory you mentioned and the pack was there. the issue was with the installation hence i uninstalled everything related to keil and did a fresh install with a fresh licence and it worked. my MCU is visible now. thanks for the help.

Children
No data