This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How can I simulate a FRDM-KL25Z board in mVision?

Hello,

I'm newbie in Keil and mVision. I would like to know if it is possible to simulate a KL25Z in mVision because I need to run some tests but I forgot my board at office.

Thanks.

Top replies

ChenTang over 5 years ago +3 suggested

Only a small set of supported devices have the peripheral simulation support in uVision simulator debug mode, which are summarized here http://www.keil.com/support/docs/3726.htm

Parents

0 ChenTang over 5 years ago

Only a small set of supported devices have the peripheral simulation support in uVision simulator debug mode, which are summarized here http://www.keil.com/support/docs/3726.htm
Cancel
Vote up +3 Vote down

Cancel

Reply

0 ChenTang over 5 years ago

Only a small set of supported devices have the peripheral simulation support in uVision simulator debug mode, which are summarized here http://www.keil.com/support/docs/3726.htm
Cancel
Vote up +3 Vote down

Cancel

Children

No data