This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

signal and frequency

AmiR92 over 5 years ago

Hello,

I currently working on the signal and frequency in which I need to program a plan on C to make the frequency as a source with a 4 MHZ and then divided into the some part, according to the user wish (like10 kHt). I am new in this subject, so I will be very grateful if someone can help me or give me some references .
Thank you

AMiR

Top replies

Westonsupermare Pier over 5 years ago +1 suggested

Figure out what micro-controller you plan to use. Most will take a frequency input and have timer or counters which can do integer division of the reference clock. Review the data sheets for the micro...

Parents

0 AmiR92 over 5 years ago in reply to Westonsupermare Pier

thank you so much
Cancel
Vote up 0 Vote down

Cancel

Reply

0 AmiR92 over 5 years ago in reply to Westonsupermare Pier

thank you so much
Cancel
Vote up 0 Vote down

Cancel

Children

No data