• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 12 replies
  • Subscribers 21 subscribers
  • Views 15146 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't debug a project

Aikuka

Hello

I’ve been using my STM32L053 DISCOVERY board for a few months. It worked until yesterday. I wrote a program to write a 4 char array to eeprom, under my lecturers supervision, and suddenly my and four of my student mates boards “crashed“ during debugging session. I am using KeilV5.28.0.0 version, toolchain is MDK-ARM Cortex-M0/M0+ 256K.

Those are the errors that we are getting:
E310  : Debug access failed - cannot read address 0xF0000FE4 (accsize ‘4’, AP ‘0’)
Error: Flash download failed - Target DLL has been cancelled

We tried reinstalling the drivers and restarting our computers. We also tried reflashing firmware with STM32CubePrg, changed debug connecting settings in project options - neither of the above works to solve our problem.

Anyone has any ideas how to solve this?

Adding a picture of the errors I am getting:

Parents
  • 0

    I have stm32mp157a and a similar error, it helped me:
    1. uncheck “Debug Description - Enable” on the Pack tab.
    After that, the device disappears from the SW Device list on the Debug tab - but this is not an error.
    2. uncheck “Update Target before Debugging” in Utilities tab

Reply
  • 0

    I have stm32mp157a and a similar error, it helped me:
    1. uncheck “Debug Description - Enable” on the Pack tab.
    After that, the device disappears from the SW Device list on the Debug tab - but this is not an error.
    2. uncheck “Update Target before Debugging” in Utilities tab

Children
No data