I have a TIVA launchpad TM4C123GHPM. I was able to Debug the board/code with IAR and CCS. With uVision, when i go to Debug tab, I do not see the Stellaris ICDI option from the dropdown to select the ICDI. I am using uVision 5. I do see CMSIS-DAP Debugger option but no Stellaris ICDI. Am i missing anything during the uVision installation? Please advise.
You can use an external debug adapter to connect to the SWD interface, as mentioned in below link:
http://www.ti.com/lit/ug/spmu296/spmu296.pdf
- The Pack Installer of MDK 5.29 confirms the support of the Tiva C123x series
Hi,
So I looked at the release note and found that in 5.29 folks have removed Stellaris ICDI support altogether. Now, what do I do in order to debug my code on TIVA C Series launch pad board using uVision. I did try installing legacy support for 5.25. But that obviously still will not allow usage of Stellaris ICDI in uVision529. Is there a way of using older uVision4, or can I get installation of uVision525. I do not see any way of downloading older limited size eval version. Can anyone advise?