Keil forum Breakpoint in ISR does not allow single stepping with XDS110 debugger

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Breakpoint in ISR does not allow single stepping with XDS110 debugger

I am running an application on the simplelink evaluation board MSP-EXDP432E401Y with the XDS110 debugger that is integrated into the eval board. When I insert a breakpoint into an ISR the break happens but I am unable to do anything but hit run again. There is no single stepping capability. Single stepping works fine outside the ISR. Is there a compiler setting that should be set?

Top replies

Westonsupermare Pier over 6 years ago +1

Googling your " MSP-EXDP432E401Y " board leads me back here, You mean this? http://www.ti.com/tool/MSP-EXP432E401Y Is there something else interrupting the interrupt you've stalled? Perhaps try...