After programming EDM1070XX (LPC1857) with ULINK2 I have to power cycle the board to get my code to run. I have tried various options in the Target Driver Setup without success.
My ULINK2 works fine with my LPC2478 boards.
I can control the board by starting a Debug Session, and the reset function works during Debug. However I just want to use ULINK2 to program the board and immediately run the code just like I do with LPC2478!
Any help would be much appreciated.
Guess you'd want to check the pins exported to the JTAG header, and any boot option jumpers. And perhaps change the ULINK reset/connection options/configuration.