Keil forum ULINK2 & MCB2140

State Not Answered
Locked Locked
Replies 1 reply
Subscribers 22 subscribers
Views 603 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ULINK2 & MCB2140

Tina Karlsson over 18 years ago

Hi

Can I use the ULINK and MCB2140 board while running uvision in the eval mode?

regards
Tina

Parents

0 Suvidh Kankariya over 18 years ago

Yea u can use the debugger.
Only restriction is to the size of your code + data + idata < 16K

Suvidh
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Suvidh Kankariya over 18 years ago

Yea u can use the debugger.
Only restriction is to the size of your code + data + idata < 16K

Suvidh
Cancel
Vote up 0 Vote down

Cancel

Children

No data