I received the board on 13 Nov 2006, when i powered, was displaying message and i build and down loaded original Blinky project, the cursor was moving at different rate by changing POT no LED were blinking (as suppose to left to right from the example),
Today LCD display is not getting initialized, only first line all dot ON and no LED is turning off. But i am able load and debug with development kit, but no action is felt.
Please advice what is wrong?
Can the board addressed using ULINK?
Yes, down load, run, step into and setting break point is operational but LCD/LED's donot turn on or off.
use the example from C:\Keil\ARM\RV30\Boards\Keil\MCBSTR9\Blinky for Keil demo board