• State Not Answered
  • Locked Locked
  • Replies 17 replies
  • Subscribers 22 subscribers
  • Views 3304 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

128x64 LCD module

Andrew Jordan

Hi

I have been learning to use 128x64 LCD module with AT89C51 and I have been using FastLCD for converting bmp into a table of bytes.

I have use the table in my codes and tried to compile it. I get the result - auto segment too large.

How to put all bytes in my codes in order to display picture on my 128x64 LCD module.

I don't understand it. What is the problem?

Manoz Joshi

Parents
  • 0 in reply to erik malund

    Fine

    You are right. I better take Andy's advice and go through everything.

    I have been using keil software for a while but the problem is how do I know that my codes will be fitted within the data memory in any microcontroller chip? Then I can select the microcontroller carefully in the future.

    Manoz Joshi

Reply
  • 0 in reply to erik malund

    Fine

    You are right. I better take Andy's advice and go through everything.

    I have been using keil software for a while but the problem is how do I know that my codes will be fitted within the data memory in any microcontroller chip? Then I can select the microcontroller carefully in the future.

    Manoz Joshi

Children
No data