We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I am using 2 Boards with the same layout (C167CR-LM, 1MB Flash, 256K RAM) for testing. No my problem is: ----------------- With the first Board downloading the programm in RAM with MON166 using the Bootstrap-Mode works fine. I can start and stop and proceed the programm as often as i want to. With the 2nd Board I can download the programm but after starting it (sometimes immedially after downloading) the connection to the board is lost and sometimes MON166 says: "CANNOT WRITE BREAKPOINT" If I write the programm into the flash on both boards everything works fine. But 'cause both Boards are the same It couldn't be an error in the Config.INC/Start167.a66, could it? Has anybody an idea what the cause could be? (I have already done a RAM-Test but everything seems to be ok) Thanks Torsten
Hello Erik, Thanks for your answer. Unfortunally i've already checked the Vcc, the timings and on my board is already a MAX232 driver too. I use a RC reset for the CR167 cause in the Datasheet by Infineon this is recommended, what would be a better option for the Reset instead of a RC circuit? best regards, Torsten