Good Day, i am writing a code for a density based traffic light project using for loops for the density part of the system, but my for loops wont execute. the code is attached below.
Agreed, but I have to admit to finding it very odd that someone could find the time to write so much about formatting and tabs and editors while not spending very little time looking at the code.
the issue is not what takes the most time (BTW you are reversed in that) but the fact that readable code is even a benefit to the OP.
there has been cases where the result of an OP being advised to "line up" the code has resulted in the OP posting "OH, now I see"
anyhow, I have a suspicion
WHICH CHIP?
BTW you are reversed in that
Not sure what you're meaning by that. But hey-ho.
Of course, a very valid point. But we don't know what the code looks like on the OP's computer (though I'd hazard a guess that it's not as bad as this Keil forum likes to make things). Again, in this instance, there's so little there. The basic code structure is simple. Really, really, really, really simple. Way simpler than much of the really badly formatted tosh that sometimes appears here. Way simpler than much of the well formatted tosh that sometimes appears here.
Yes, I'll say it. I guess I just have an aversion to OTT (aka anal) responses.
Yes, a very appropriate question.