A part of the code where it goes wrong in pil_symbols_c.c is shown below:
//this file can be linked such that no Flash memory is consumed #ifndef PIL_PREP_TOOL #include "pil_symbols_c.inc" // will be automatically generated #endif
A part of the code where it goes wrong in pil_symbols_p.c is shown below:
// this file can be linked such that no Flash memory is consumed #ifndef PIL_PREP_TOOL #include "pil_symbols_p.inc" // will be automatically generated #endif
Also, I don't know how to link those two files such that no Flash memory is consumed.
My main problem is that I get the following error when building the code and I would like to get some help. In the same folder there are like approximately ten .c and .h files in which there are no problems found when building the code.
*** Using Compiler 'V5.06 update 3 (build 300)', folder: 'C:\Keil_v5\ARM\ARMCC\Bin' Build target 'BLDC_F401RE_USART' compiling pil_symbols_p.c... Common\pil_symbols_p.c(28): error: #5: cannot open source input file "pil_symbols_p.inc": No such file or directory #include "pil_symbols_p.inc" // will be automatically generated Common\pil_symbols_p.c: 0 warnings, 1 error compiling pil_symbols_c.c... Common\pil_symbols_c.c(28): error: #5: cannot open source input file "pil_symbols_c.inc": No such file or directory #include "pil_symbols_c.inc" // will be automatically generated Common\pil_symbols_c.c: 0 warnings, 1 error ".\Common\Demo\BLDC_PIL.axf" - 2 Error(s), 0 Warning(s). Target not created. Build Time Elapsed: 00:00:03
I think it's best if I just share the project so perhaps you experts can give it a try. I only would like to build it and flash it on my stm32.
I have uploaded the original project to my drive and the link is:
drive.google.com/open
So many thanks all of you, I hope you can figure it out and let me know (it's approximately a 2mb file).
Should you be asking here: https://www.plexim.com/support ... ?