Keil forum is there an utility to ONLY flash HEX files?

State Not Answered
Locked Locked
Replies 2 replies
Subscribers 17 subscribers
Views 941 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

is there an utility to ONLY flash HEX files?

J G over 8 years ago

Hi,

I am using Keil uVision4, and ULINK2, but I am not working on development right now only flashing boards.

Is out there a simpler Keil SW tool to only Flash *.HEX files in to a Freescale ARM CortexM MK60DN256xxx10.

Perhaps not specifically Keil but something that you can recommend me to use compatible with the ULINK2.

Thanks,

Parents

0 Westonsupermare Pier over 8 years ago

And you can't use the .ELF that created the .HEX?

Keil doesn't provide any stand-alone utilities. You want something like that, consider Segger J-Link. Does Freescale provide any low cost solution? ST has the ST-Link + Utilities
Cancel
Up 0 Down

Cancel

Reply

0 Westonsupermare Pier over 8 years ago

And you can't use the .ELF that created the .HEX?

Keil doesn't provide any stand-alone utilities. You want something like that, consider Segger J-Link. Does Freescale provide any low cost solution? ST has the ST-Link + Utilities
Cancel
Up 0 Down

Cancel

Children

0 Franc Urbanc over 8 years ago in reply to Westonsupermare Pier

http://www.keil.com/support/man/docs/uv4/uv4_fl_hexdownload.htm
Cancel
Up 0 Down

Cancel