Hi Guys, i just installed the newest Keil uVision to Programm and Debug STM32F0 Microcontroller via ST-Link. Programming and flashing via ST-Link works fine. But when i try to use the debugger i can´t set breakpoints. If i set breakpoints before i switch to the debugger they transfer to a exclamation mark.
please see this picture: [img]up.picr.de/22284985rp.jpg[/img]
whats wrong? i hope you guys can help me.
thanks a lot
best regards
Max
I'm having the same problem. I've set 2 breakpoints in total: 1 at the start of main() and one a bit further ahead within the main function.
I know the code runs fine on the discovery board, since the LEDs are doing what I'm asking them in code. However the debugger shows the breakpoints as greyed-out (while again I'm 100% certain the MCU actually gets to that part of the code).
I quadruple checked all of the project settings such as debugger (ST link v2), memory addresses and sizes (SRAM and Flash), etc etc etc.
No idea what the reason is this doesn't work...