Hi Guys, i just installed the newest Keil uVision to Programm and Debug STM32F0 Microcontroller via ST-Link. Programming and flashing via ST-Link works fine. But when i try to use the debugger i can´t set breakpoints. If i set breakpoints before i switch to the debugger they transfer to a exclamation mark.
please see this picture: [img]up.picr.de/22284985rp.jpg[/img]
whats wrong? i hope you guys can help me.
thanks a lot
best regards
Max
Current firmware and drivers for the ST-LINK?
The Cortex-M0 has limited breakpoints, between 0-4, Keil likely has used a couple for it to reset and run-to-main.
How many breakpoints does the STM32F0 have? How many have you used?