This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem During Burning a Program Through Programmer

I HAVE COMPLETED A CODE IN C FOR AT89C2051 MCU..IT IS WORKING CORRECTTLY ON PROTEUS DESIGN BUT WHEN I AM GOING TO PROGRAM THE IC THROUGH PROGRAMMER IT PROGRAMS BUT VARIFICATION FAILS AT 1BYTE...PLS SMONE HELP ME OUT FROM THIS??/

Parents

0 ²erik malund over 10 years ago in reply to chandan pandey

there are really many posts in various places that all end up "after I replaced my xxx programmer with the Atmel $25 device, it worked".

The Atmel devices are, for programming, super sensitive re timing and levels
Cancel
Vote up 0 Vote down

Cancel

Reply

0 ²erik malund over 10 years ago in reply to chandan pandey

there are really many posts in various places that all end up "after I replaced my xxx programmer with the Atmel $25 device, it worked".

The Atmel devices are, for programming, super sensitive re timing and levels
Cancel
Vote up 0 Vote down

Cancel

Children

No data