Hello,
I'm observing a strange behavior when I start a debug session and run the application code. If I stop code execution I cannot perform a reset by clicking the RST button on upper-left corner of uVision4 IDE V4.22.22.0. Could anyone help me with this issue?
regards, gaston
Is the NRST pin connected on your JTAG pod? Or otherwise oddly connected on your board? Is yours the only code the processor might be expected to execute at reset? ie a boot ROM, or a memory other than the one your code is situated.
yes, here's my JTAG configuration
www.dropbox.com/.../jtag-ARM.png
BTW, the code is situated in internal Flash Memory