This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LPC1800 Development board

Hi,

I am using a MCB1800 development board. For programming the board i need a UNLink Debugger. Can I instead use H-Jtag software to program the board using parallel port to jtag.

Regards
Sanket

Parents

0 Offline Westonsupermare Pier over 8 years ago in reply to sagar salunkhe

Depends if stand-alone programming is what you're looking for, or the ability to program and debug (step, breakpoint, etc).

The documentation and materials for H-JTAG should tell you if the LPC1800 is supported or not, and stand-alone programming is outside the purview of the Keil tools, and integration therein.

If you want to do some debugging it's strongly recommended that you look at JTAG/SWD debugging pods. If you are an educational user, perhaps consider a JLINK-EDU type solution which supports multiple platforms and chips.
Cancel
Up 0 Down

Cancel

Reply

0 Offline Westonsupermare Pier over 8 years ago in reply to sagar salunkhe

Depends if stand-alone programming is what you're looking for, or the ability to program and debug (step, breakpoint, etc).

The documentation and materials for H-JTAG should tell you if the LPC1800 is supported or not, and stand-alone programming is outside the purview of the Keil tools, and integration therein.

If you want to do some debugging it's strongly recommended that you look at JTAG/SWD debugging pods. If you are an educational user, perhaps consider a JLINK-EDU type solution which supports multiple platforms and chips.
Cancel
Up 0 Down

Cancel

Children

No data