This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

switch between c167cs and st10

I currently have a working project for the C167. I need to port this application to the st10f273. How do I convert program and setup the compiler and tools for the st10?

Parents

0 Westonsupermare Pier over 11 years ago in reply to ²erik malund

>>but that is in machine code and no ARM is going to run c16x machine code

Pretty sure you'll find that the ST10 isn't ARM based.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Westonsupermare Pier over 11 years ago in reply to ²erik malund

>>but that is in machine code and no ARM is going to run c16x machine code

Pretty sure you'll find that the ST10 isn't ARM based.
Cancel
Vote up 0 Vote down

Cancel

Children

No data