Hello guys, I am newbie here. I would like to make a programme that take from 2 channels ADC and via DMA store them in an array and then shows flags HT and TC.Do u have any example? How can I set an input of 600 khz?
I think I'd tend to agree.
"wouldn't a board like an STM32F3-Discovery, or STM32F4-Discovery be a better choice here? Low cost, built in debugger..."
I think so: I don't really see that the Simulator gives much (if any) advantage over a Discovery board - and you don't get the added "uncertainties" of simulation...
"I don't really see that the Simulator gives much (if any) advantage over a Discovery board"
That should be:
I don't really see that the Simulator gives much (if any) advantage over a Discovery board or similar
That is: a cheap, simple, well-supported board with on-board debug.