Hi,
I am having problems getting USB host running.
Platform: STM32F407
I see in usbh_stm32f40x.c a conditional __XYNERGY. What is this conditional for? If it is not defined, then PH5 is used for something (not sure what, not sure if it is even important for just a usb host application). PH5 is a non-existing pin on my platform!
Should I define __XYNERGY or not?
Kind regards, Ruud
Additional: Are these OTG_SW_ON/OTG_FS_PS signals the same as what on my pinout is called:
OTG_FS_VBUS (PA9 pin)?
And should I change this in usbh_stm32f40x.c?