Hello!
I have a board working with LPC2368 uC, I talked to some NXP representative and he told me that LPC1769 were pin compatible.
The problem is, the board works fine with LPC2368, but when I change to LPC1769 I upload the code with success using Flash Magic, but anything works..even a simple blink LED test, the pins state go crazy.. Nothing works..
Does anybody know if I have to do some extra configuration in uVision4 to work with LPC1769? Or another configuration in Flash Magic?
Waiting for your help!!
So the answer is that you have not checked the chapter about the built-in monitor - and have not checked on the serial port if the processor is waiting in the boot loader instead of starting any program.
Problem is - we can't check it for you.
What, exactly, do you expect from this forum? The user manual for the processor is mandatory reading for everyone using the processor. And the chapter about in-system programming is very much relevant to this problem.
Problem solving is about trying different things to try to collect enough evidence to finally know what is wrong.
But we can't spend significant time explaining the information that is available in this chapter of the manual. That would cost us lots of time. Time that we can spend on better things. After all - it isn't our project that is stuck with this problem.