I use Keil sometimes and while using a timer in autoload mode, the TH0 is loaded with the calculated value but TL0 starts incrementing from 00 instead of the calculated value F0.Am I missing something while using or configuring the keil simulator?
The code clearly states
Nonsense. What "code" you showed us here doesn't state anything clearly.
that its polling and interupt mode.
And that's an obvious self-contradiction.
all I am getting are replies which does not solve my problem.
That's because you failed quite spectacularly at presenting what your problem even is.
the above code works perfectly well when run on keil simulator in mode 1. It does work when using mode 2.
So it works in both modes, you say. What was your problem, again?
"Nonsense."
no reason to be so harsh.
yes, his posts were not the clearest; and his mastery of english words wasn't as smooth as yours.
but he got the gist of his points across after a few tries.
maybe you can ask him for more clarification, but there is no point in beating down a newbie to establish your superiority, because everyone of us was a newbie in the not-so-distant past and will be a newbie in the not-so-distant future on some matters.
so be kind and stop being an @#$@
"so be kind and stop being an @#$@"
Oh brother! That from the like of you, who is without question the biggest, most overt "@#$*" we've had on this forum, the Microchip forum, and the HI-TECH forum! Sheesh!