Hi 2 all, Actually iam doing a project where i have to convert the analog voltage to digital and read it's output. I have done the program for generating the sclock and ss/ for ADC(Max187) and getting the serial 12 bit data output successfully.... But iam not able to convert this serial 12 bit data to parallel using 89C51 controller... Can anyone help me by giving some hints or a sample program for it please....
Hi, I can't able to save my program in .hex file. Actually i had written a program but whil iam saving it as .hex file and load the the program it is detecting as Binary but not as Intel Hex file. Can anyone say why iam getting this problem please... Thanks...
"I can't able to save my program in .hex file"
Did you follow the instructions here: http://www.keil.com/support/man/docs/uv4/uv4_ca_createhexfile.htm
"whil iam saving it as .hex file..."
What do you mean by that?
You don't "save it as" a hex file; the build process creates the hex file for you - assuming you configured your project correctly (see above), and that the build completed without problems.
Have you checked that a hex file is created?
Have you checked that it is actually a valid hex file? see: http://www.keil.com/support/docs/1584.htm
"...and load the the program it is detecting as Binary"
What, exactly, is "detecting as Binary" ?
"Can anyone say why iam getting this problem please..."
Not on the description you have provided! You need to take more care to clearly explain pricesely what steps you are taking, what tools you are using, and what results you are seeing.
Remember: nobody knows anything about you, or your project, other than what you clearly describe in your posts! We cannot read your mind; We cannot see your code; etc, etc,...
Do you not have any colleagues, tutors, mentors, or other local support?
Thanks pardon for ur reply... My problem is solved by ur reply post... Thanks very much...
Actually my project is to convert the analog signal input to digital. So for providing the Sclock and SS for Max187(ADC IC) iam using 89c51 IC. This MAx187 will produce 12 bit serial data as output(analog signal which is converted into digital). And i have take that serial digital data output from MAX187 and have to convert agian into parallel data using again same 89c51. Can u send me anycode for doing it please... I have done already a program for it where i can get a digital data from Max187. But iam not getting to convert this serial data to parallel.... Can u help me in this problem also please...
Thanks....