Keil forum Oregano 8051 register R0 and R1 are not direct accessable

State Not Answered
Locked Locked
Replies 13 replies
Subscribers 22 subscribers
Views 2438 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Oregano 8051 register R0 and R1 are not direct accessable

nanswamy n over 14 years ago

HI ,

I wanted to use the oregano 8051 free core and evalaute for using in a design.

wanted to simulate to check for the 8051 instrution set.

I find that Oregano 8051 MCU register R0 and R1 are not direct accessable.

example: MOV R0,#80H does not work.

Is that an issue?

Thanks in advance
Swamy

Parents

0 ²erik malund over 14 years ago in reply to Andy Neil

In other words, they expect you to contribute

how many to you think expect that expectation.

I have (besides cooking) no knowledge of oregano but based on seen posts elsewhere VERY few SDCC users 'contribute'

Erik
Cancel
Vote up 0 Vote down

Cancel

Reply

0 ²erik malund over 14 years ago in reply to Andy Neil

In other words, they expect you to contribute

how many to you think expect that expectation.

I have (besides cooking) no knowledge of oregano but based on seen posts elsewhere VERY few SDCC users 'contribute'

Erik
Cancel
Vote up 0 Vote down

Cancel

Children

0 Andy Neil over 14 years ago in reply to ²erik malund

Far too few.

:-(
Cancel
Vote up 0 Vote down

Cancel